Jayco SENECA, Руководство пользователя

Страница: 33 / 93

SECTION 4
VEHICLE OPERATION
To activate this feature, use the “Mirror Heat”
control located on the driver’s side console
next to the mirror control.
NOTE : To prevent
the batteries from running down, operate the
power remote mirrors when the chassis
engine is running.
R
EAR
V
ISION
C
AMERA
Your motor home is equipped with a rear
vision monitor that gives a limited televised
view of what is behind your motor home. The
rear vision camera will aid you in backing up
the motor home, and can be used for a
greater field of vision when driving in heavy
traffic.
Check the outside rear view mirrors when
driving and backing up the motor home for a
more complete field of vision.
Objects in the camera/monitor view can be
closer than they appear. To become
accustomed to using the rear view camera
monitor, practice backing up in a safe place.
If in doubt, ask another person outside the
vehicle to assist.
The monitor is operational whenever the
engine is running. To use the monitor, flip the
switch from standby to ON (the monitor will
also work when with the motor home is in
“reverse” and the monitor in standby). Make
sure you turn the monitor to standby while
driving to avoid being distracted.
Never operate the rear vision monitor in the
ON position for extended periods of time as
this may result in an "image burn" on the
monitor.
L
EVELING
J
ACKS
Before operating the system
The hydraulic leveling jack system should
only be operated under the following
conditions:
1. Park the motor home on reasonably solid
surface or jacks may sink into the ground.
On extremely soft surfaces use load
distribution pads under each leveling jack.
2. Check that potential jack contact locations
are clear of obstructions or depressions.
3. Keep people clear of the motor home prior
to turning the leveling system ON and
while the leveling system is in operation.
4. Engage the parking brake.
5. Make sure the transmission gear selector
is engaged in NEUTRAL or PARK.
6. The engine must be running for the
leveling system to operate.
The following label should be kept
permanently affixed by the leveling jack
control panel located in the command center:
Fig. 4.1 Leveling jack label
Never expose hands or other parts of the
body near hydraulic leaks. High-pressure
oil leaks may cut and penetrate the skin
causing serious injury.
The rear vision camera aids in the use of,
but does not replace vehicle side/rear-view
mirrors.
Objects in the camera view are closer than
they appear. When backing up, proceed
cautiously and be prepared to stop.
Before operating the hydraulic leveling
system:

Check that potential jack contact
locations are clear of obstructions or
depressions.

Keep people clear of the motor home
prior to turning the leveling system ON
and while the leveling system is in
operation.
4 - 3