Jayco PINNACLE FIFTH WHEELS 2019, Руководство пользователя

Страница: 85 / 185

83
Section 6: Electrical System
GFCI Receptacle
There is a ground fault current interrupter (GFCI) engineered into the electrical system. It is
designed to reduce the possible injury caused by electric shock. The GFCI will not protect
against short circuits or circuit overloads.
Test all GFCI receptacles monthly:

Push in the GFCI “TEST” button. The GFCI “RESET” button should pop out
indicating the GFCI receptacle has been “tripped” and interrupted 120-volt power.

Push in the GFCI “RESET” button to restore 120-volt power.
Contact your independent dealer for assistance if the GFCI “RESET” button does not re-
store 120-volt power and pops back out.
A “tripped” GFCI breaker indicates that abnormally high 120-volt current flow (a ground
fault) was detected. All ground faults must be repaired before use of the recreation vehicle.
If the GFCI “RESET” button does not restore 120-volt power and pops back out. Contact
your dealer for assistance.
LCI One Control® System
This system gives you control over most functions in your
recreational vehicle from any one of (3) touch screen control
panels located throughout the RV. The touch screen control
panels will operate awnings, the leveling system, interior/ex-
terior lighting, monitor panels, slide-outs etc.
The One Control System will
NOT
operate the hall light,
lights located inside each slide-out, exterior amber/red mark-
er lights, or the LED strip lights located on the front or rear
caps.
These devices can also be controlled with:

Downloadable Wi-Fi phone app, The LCI One Control App can be downloaded
to Android and Apple devices from GooglePlay or the Apple Store. Once the app
is installed on your phone or tablet, you will be able to control these components
through your device.

Command center switch panel.

At the exterior utility center (for pump operation).
Wall mounted touchscreen controls
Two additional 5” touchscreens are located in the living area and
bedroom. These do not require a PIN code to operate. Press the
button at the bottom of the screen to activate the screen and open
the selection menu. Operation is identical to the main touchscreen.
Arrows at the side of the screen allow you to scroll for more items.
Wi-Fi Operation of the One Control® System
A wireless router is installed that connects to the One Con-
trol® System. The label at the router location
(Fig 2)
has
the password for the wireless router (8 alpha characters
and case dependent). This password is necessary when
connecting the One Control® System to an Android or
Apple smartphone or tablet. The router is typically located
in a cabinet near the main touch screen.
5” Touchscreen
Table of Contents Maintenance Record