Jayco PINNACLE FIFTH WHEELS 2019, Руководство пользователя

Страница: 116 / 185

114
Section 8: Plumbing System
Water Pump Switch (if so equipped):
Most water pump switches illuminate when the water pump is activated. In most models,
the (red) pump switch is located on the monitor panel or the utility center. When the water
pump switch is ON the pump runs until 45 lbs. of pressure has been achieved. The red light
will stay on. The water pump automatically recycles when pressure drops. Some cycling
may occur depending on the volume of water being released. Turn the water pump switch
OFF when it is not in use.
The water pump switch should be in the OFF position when the RV is left unattended
for any amount of time. If something would happen to the water system, this may help
limit water damage to a smaller area.
Water Purification System (if so equipped)
If equipped with a water purification system:
 If the water supply has not been used for some time, allow the water to flow for
several minutes to flush the system.
 Filters should be replaced at the beginning of each camping season or if they
have come into contact with contaminated water.
 When not in use, the water filter cartridge should be stored out of freezing tem
-
peratures. RV antifreeze will damage the water filter cartridge.

Filter canister is typically located in a compartment behind the utility center.
To Replace Canister Filter Cartridge:
1.
Turn off water supply using two valves located on the water lines on each side of the
canister. Water pump should be OFF.
2.
Place drip pan below filter housing to catch any spillage.
3.
Press the red button on top of the filter housing to release pressure.
4.
Using a spanner wrench, rotate the filter housing. Unscrew the
housing completely, dump water out and remove the filter (dispose
of the old filter properly.
5.
Clean the inside of the filter housing with mild detergent. Thor
-
oughly rinse and wipe clean.
6. Remove the O-ring from the groove in the housing and wipe clean.
Recoat with petroleum jelly.
7. Replace the O-ring in the groove, making sure it is properly seated.
8.
Install the new filter cartridge.
9.
Replace the canister housing (hand tighten is normally sufficient).
10. Turn on the water supply, turn the pump ON, open a faucet and
check for leaks. Turn the pump OFF afterwards.
Filter Housing
NOTE: In some models the
water pump switch will be a black
rocker switch located near the sink
cabinet
Maintenance Record Table of Contents