Jayco PINNACLE FIFTH WHEELS 2019, Руководство пользователя

Страница: 122 / 185

120
Section 8: Plumbing System
“CITY WATER” (Pressurized fresh water source)
1. Connect the fresh water hose to the city water inlet.
2. Set the color coded valves to the CITY WATER setting:

(A) White handle pointing right

(B) Blue handle pointing down

(C) Black handle pointing right

(D) Red handle pointing up

(E) Green handle pointing up
3. Connect other end of the hose to the pressurized fresh water source.
4. Turn ON the pressurized water source.
5.
Water should now be available to all fixtures.
To disconnect: Turn off water at the pressurized source first, disconnect hose from the
water source, (to release pressure off the system) then disconnect the hose at the city water
connection on utility center last.
“WINTERIZE” (plumbing lines and fixtures via pump)
1. Connect a garden hose to the city water inlet (do not use your fresh water hose to win-
terize the water lines).
2. Set the color coded valves to the WINTERIZE setting:

(A) White handle pointing down

(B) Blue handle pointing left

(C) Black handle pointing right

(D) Red handle pointing left

(E) Green handle pointing up

The water heater is bypassed automatically on this setting.
3. Insert the other end of the hose in a container holding RV antifreeze.
4. Turn the pump switch ON.
5.
Antifreeze should begin flowing into the plumbing lines and fixtures (the pump will run
when a faucet or the toilet is in use). To aid in siphoning place the container on a surface
approximately (2) feet off the ground.
6.
Open one plumbing fixture, keeping it open until antifreeze
appears then close it. Repeat for each plumbing fixture (in
-
cluding the outside shower hot & cold lines).
7. Turn BLUE, GREEN and WHITE handles so they are at a
45° angle for 10 seconds.
8.
Turn the pump OFF when all fixtures have been winterized.
9. Return all handles to the WINTERIZE setting.
10. Disconnect the hose from the city water connection inlet (it
is normal for some antifreeze to exit the inlet hose as it is
being disconnected).
11. Leave the valves set on WINTERIZE setting.
NOTE: For complete winterizing instructions, refer to the
Winter
-
izing the Plumbing System section.
Maintenance Record Table of Contents