![background image](http://html1.mh-extra.com/html/jayco/embark-2022/embark-2022_owners-manual_3570511083.webp)
77
Section 6: Electrical System
The shore power cord is designed to continuously carry the 50-amp current flow required to
power each leg of the electrical system. It also creates a critical ground connection between
the vehicle electrical system and the campground shore power receptacle.
Always test the external power source (i.e., the campsite power receptacle or electrical box)
with a ground monitor before connecting your power cord to it. If the ground monitor indi-
cates ‘reverse polarity’ or an ‘open ground’.
DO NOT connect the power cord.
Regularly inspect the shore power cord for cuts, cracks, worn insulation and other damage.
Have the power cord replaced immediately if problems exist.
Calculating 50 amp Electrical Load (if so equipped)
When connecting appliances to the electrical system, 120-volt power usage is limited to 50
amps per electrical system leg for a total of 100 amps. Operating appliances collectively
places an added load on your 120-volt electrical system.
A circuit breaker “trip” may occur if you overload the recreation vehicle and/or campground
electrical system. The amperage rating of individual appliances can be calculated by di-
viding appliance wattage consumed (normally listed on the appliance) by nominal design
voltage (120 for a 120-volt appliance). For example: 1200 watts divided by 120-volts equals
10 amps.
Generator
Your motor home may be equipped with an LP or diesel powered generator. In certain
gasoline engine motor homes, the generator will be gasoline powered as well. The genera-
tor produces 120/240-volt power compatible with the motor home electrical system. It can
power the entire motor home when 120/240-volt shore power is not available.
Power Cord Reel (if so equipped)
Electrically powered cord reel (if so equipped)
If your recreation vehicle is equipped with a powered cord reel, extend the shore power cord
using the extend/retract switch located in the same compartment near the cord reel. After
extending the shore power cord, connect the cord to the campground shore power receptacle.
Disconnecting and stowing the shore power cord
Reverse the applicable process (manual or powered cord reel) to disconnect, retract, and
stow the power cord.
Refer to and follow all safety information found in the manufacturer’s product manual in-
cluded with your warranty packet.
Before connecting shore power, it is advisable to turn off electrical power
at the source, or the unit main breaker.
Damage to electrical components caused by electrical spike, improper
ground or polarity to the unit is not covered by your recreation vehicle
warranty.
Use of an aftermarket surge protecting device between the unit shoreline
and the electrical source is strongly recommended.
Table of Contents
Maintenance Record
Содержание Embark 2022
