Jayco Embark 2022, Руководство пользователя

Страница: 76 / 165

70
Section 6: Electrical System
12-Volt Fuse Panel
The 12-volt fuse panel is labeled to indicate fuse sizes, positions and the components pow-
ered. Fuses are located in the load center.
Replacing a Fuse
Before replacing a fuse, always turn off the electrical components protected by it.
1. Disconnect the shore power cord.
2. Inverter should be OFF.
3. Remove the fuse panel cover to check fuses.
4. Pull the fuse straight out of the fuse block.
5. Insert a new fuse of the same specified voltage, amperage rating and type in the original
location.
The fuse panel label should be kept permanently affixed to your recreation vehicle. Fuses
will not offer complete protection of the electrical system in the event of a power surge or
spike.
12-Volt DC Outlet
There may be one or more 12-volt DC power outlets in your recreation vehicle. When the
12-volt DC outlet is used as a power source for an electric appliance, make sure the appli-
ance operates on 12-volt DC power and that it consumes less than 60 watts (5 amps) of
power.
Replacement fuses must be of the same voltage, amperage rating and type.
Never use a higher rated replacement fuse;
doing so may cause a fire by
overheating the RV wiring.
Keep the protective dust cap on the 12-volt DC outlet when not in use to pre-
vent ingestion of foreign material and potential short circuit conditions.
Table of Contents Maintenance Record