![background image](http://html1.mh-extra.com/html/jayco/embark-2022/embark-2022_owners-manual_3570511024.webp)
18
Section 2: Occupant Safety
Combination Carbon Monoxide /Propane Alarm
Your recreation vehicle is equipped with a combina-
tion carbon monoxide (CO) / propane alarm (RV-
COLP) that is listed for use in recreation vehicles. The
combination carbon monoxide/propane alarm will
only work if it is operational and maintained.
The alarm is directly wired to the 12-volt electrical
system, with continuous power being supplied by the
recreational vehicle batteries. There is no 9-volt bat-
tery power supply. As a result, the alarm is always
drawing a small amount of current from the recreation
vehicle batteries. Although the current draw is slight,
it could drain the batteries during extended storage
periods. This condition is not likely to occur except
during storage situations when the inverter cannot restore the battery charge.
If the battery
cable is disconnected at the battery terminals, the combination alarm will not work.
Be sure to read, understand and follow the owner’s information from the manufacturer of
the combination CO/propane alarm. This includes information regarding the limited life of
the alarm.
When the battery becomes weak, the alarm will “beep” about once a minute indicating
a low battery.
This warning should last for 30 days. You
MUST
replace the battery once the
alarms low battery warning (beep) starts to assure continued protection.
When the battery is removed from the alarm, the battery flag will pop up; the alarm cannot
be installed to the mounting bracket without a battery.
To test,
stand at arm’s length from the smoke alarm as the alarm horn is loud and may be
harmful to your hearing. The test button will accurately test all functions. Never use an
open flame to test the smoke alarm.
Do not remove the warning label located near the
smoke alarm from your recreation vehicle:
Key Features:
•
Silence Feature: Silences nuisance alarms
•
Hinged cover allows for easy battery replace-
ment
•
Lighted Power and Alarm Indicator. LED in-
dicates battery is connected.
•
Test/Silence button – One touch button combines both features
•
Low Battery indicator – Beeping signal indicates low battery.
Maintenance
Vacuum off any dust on the cover of the smoke alarm using a soft brush attachment. Test the
smoke alarm once you have vacuumed. Never use water, cleaners or solvents to clean the
smoke alarm as they may damage the alarm. Do not paint the smoke alarm.
Refer to and follow detailed safety, testing, troubleshooting and maintenance information
found in the manufacturer’s user pamphlet located in your warranty packet.
Table of Contents
Maintenance Record
Содержание Embark 2022
