seat toward the back rest to move the unit
into the set up position.
4. To move it back into the bed position, pull
up on the front edge of the seat to create
the V-shape.
5. Push down on the top of the back rest and
the front edge of the seat to lay it into the
bed position.
6. To store the couch/dinette against the wall,
it is necessary to have it in the bed
position.
To complete the dinette set up, position the
table between the dinette seats.
J-Steel dinette and couch removal
The J-steel dinette and
couch are designed for
removal from the wall to
create more room in the
cargo area.
Loosen the thumb bolt
securing the bracket to
the trailer wall.
1. Lift up on the J-steel
frame to remove it from the bracket.
2. Store and secure the J-steel dinette/couch
in an appropriate place while traveling.
3. To set up, return the J-steel frame to the
appropriate bracket.
4. Tighten the thumb bolt to secure the
dinette/couch in place.
The
thumb
bolt
securing
the
J-steel
dinette/couch frames must always be
tightened when to prevent the J-steel from
detaching from the bracket and damaging
the trailer.
R
EAR
B
ED
(I
F
S
O
E
QUIPPED
)
Power operation (if so equipped)
The electric bed lift operates on 12-volt DC
power supplied by the tow vehicle charge line,
auxiliary batteries, or power converter. The RV
should be hooked up to 120-volt AC power and
have
the
power
converter
operating,
if
possible.
There are two separate switches used to
operate the bed lift: a backlit master shutoff
switch located near the entry door and a bed
lift “Up/Down” switch located elsewhere in the
trailer.
0
The master switch must be in the “ON”
position for the “Up/Down” switch to be
operational.
0
To lower the bed lift, press the “DOWN”
section of the “Up/Down” switch. Lower
the bed to the desired position or until it
automatically stops at its lower limit.
To store the bed, remove any obstacles laying
on the bunk. Press the “UP” section of the
“Up/Down” switch. Raise the bed to the
desired position or until it automatically stops
at its upper limit.
70
SECTION 10
CAMPING & OPERATING
Fig. 10.3 Thumb
bolt
WARNING
RAISE
THE
REAR
BED
TO
THE
HIGHEST POSITION WHEN TOWING
YOUR RV
. Damage to the rear bed may
result from traveling with the bed in lowered
positions.
WARNING
DO NOT LOAD MORE THAN 600# ON
THE
BED.
Damage
to
the
bed
lift
mechanism and personal injury may result
from overloading.
Содержание 2008 Octane ZX
