AAA-055-00084
Jaylor Operator’s Manual
- 55 -
Twin Auger Trailer Units
DRUM EXTENSION INSTALLATION (IF APPLICABLE)
Depending on the Jaylor model and options you have chosen, your machine may be equipped
with a plastic (HDPE) drum extension. If so, please follow these steps to install the extension on
your twin auger machine:
1. Begin by unrolling both lengths of the HDPE extension. Measure the full length of one of the
sections and mark the half way point. Each section should be 38’ in length.
2. Line up the half way point of this section with the center rear of the drum, so that the extension
sits flush on the angle iron at the top of the drum.
3. Using the holes in the angle iron as a guide, drill a hole (1/2” diameter) in the extension and
fasten to the angle iron at or near this center rear point on the drum. Make sure that bolt heads sit
on the outside of the extension.
4. Wrap the two ends around the angle iron as shown in Figure 18 below. Clamp both ends to the
angle iron, making sure that the extension is pulled as tight as possible.
Figure 18 Securing First Extension Section
5. Repeat steps 1-4 for the second extension section, but start at the center front of the machine.
Wrap both ends so that they overlap the first extension section. Clamp both ends to the first
extension section as shown in Figure 19 below.
