AAA-055-00084
Jaylor Operator’s Manual
- 28 -
Twin Auger Trailer Units
•
Attach the driveline to the tractor by retracting the locking pin, slide the yoke over the
shaft and push on the yoke until the lock pin clicks into position. Pull on the yoke to be
sure the driveline is locked on the shaft.
11. Connect the hydraulics:
•
Use a clean cloth or paper towel to clean the couplers on the ends of the hoses. Also
clean the area around the couplers on the tractor.
•
Insert the male ends of the couplers into the remote hydraulic ports on the tractor.
•
Be sure that each hydraulic circuit on the machine matches up with the correct set of
ports on the tractor. Be sure to match the system with the desired control lever in the
tractor.
12. Connect the wiring harness and scale indicator power cord.
13. Route the hoses and wiring harness along the hitch and secure in position to prevent
entanglement with any moving parts.
14. Raise the implement jack, remove and mount on the upper storage bracket.
15. When unhooking from the tractor, reverse the above procedure.
Figure 8 - Typical Attachment to Tractor showing Hitch hookup, PTO shaft
hookup, Wire harness and Hydraulic Connections.
