AAA-055-00084
Jaylor Operator’s Manual
- 26 -
Twin Auger Trailer Units
On the bottom of the indicator are 3 outlets for attaching the 3 weighbar cords. These should not
be confused with the power supply, which will not attach in the same outlet. The weighbar cords
are pushed in, and then the tightening ring threaded into place. Make sure that the plugs are free
of moisture or other contaminants, as this will affect the performance of the weighing system.
On standard models, the power cord is to be plugged into the tractor female receptacle, which
should be mounted on your tractor, getting its power supply from the tractor’s electrical system.
This should be a 12-volt negative ground power supply.
For machines using a self-contained battery, the female receptacle is connected directly to the
battery.
Warning:
To avoid injury or death, always follow all safety and operational instructions and
constraints pertaining to the battery, to avoid injury or death.
Some models may be equipped with a second indicator, referred to as the Remote Indicator. This
indicator is usually adjusted such that viewing from the loading equipment is permitted. In most
cases the remote indicator does not allow full access to weigh system parameters. These are
usually controlled from the main indicator as described earlier. The remote indicator attaches to
the main indicator via a cable. Like all of the other connections, ensure that the plugs are free
from any moisture and other contaminants as this will affect the performance of the weighing
system.
Note:
The scale will be programmed to display weight in either kilograms (kg) or pounds
(lbs.). This is set by the manufacturer and must be ordered to suit. If your scale is not
programmed to your preferred units of measurement, please contact your local Jaylor
Dealer.
Note:
For complete information on Scale Operation and Settings, see the attached scale
manufacturer’s Users Manual.
