Gb
Fr
- 74 -
324501E
revision02
De
V1 V2 V3
JP1 JP2 JP3
V1 V2 V3
JP1 JP2 JP3
V1
V3
V2
JP1
ON
OFF
JP2
JP3
JP4
5.10- Receiver parameter erasing procedure
This procedure has the following effects :
- Erasing of all programmed transmitter(s) / receiver(s) associations,
- Erasing of all programmed interlockings,
- All relays operating mode turn by default mode : «Continuous make contact»
z
The receiver parameter erasing procedure is done from the receiver by
JP1
,
JP2
and
JP3
jumpers/microswitches.
1- Switch off
industrial receiver (ORRA or ORRS), the receiver on DIN rail (ORRD)
can remain power supplied during all the procedure.
2-
For the ORRS and ORRA industrial receivers, place jumpers
JP1
,
JP2
and
JP3
in the short-circuit position, for the ORRD receiver, set microswitches
JP1
,
JP2
and
JP3
to the «ON» position.
)
)
)
)
)
Only the radio channel
setting is preserved
3-
Switch ON «industrial» type receiver (ORRS and ORRA).
4-
-
V2
and
V3
LEDs flash 5 times during the parameter erasing, then go off
(except on ORRD DIN rail receiver, indicator lights stop to blink for a few time
and re-start to blink 5 times etc...).
All the receiver parameters (except the radio channel setting) are erased.
5-
Switch off the receiver and remove jumpers
JP1
,
JP2
and
JP3
(ORRS and
ORRA) , or set microswitches
JP1
,
JP2
and
JP3
to the «OFF» position
(ORRD) and proceed to a new programming.
ORRS receiver
ORRA receiver
ORRD receiver
Содержание OREi21SL1
