Jay electronique OREi21SL1, Инструкция по установке и эксплуатации для пользователя

Страница: 62 / 140

Gb Fr
- 62 -
324501E
revision02
De
V1 V2 V3
JP1
JP2
JP3
JP2
JP4
V1 V3 V2
JP3
ON OFF
JP1
V1 V2 V3
JP1
JP2
JP3
5.3- «
Standard
» association of transmitter
button(s) with receiver relay(s)
This procedure is used to :
• Automatically erase the previous settings in the receiver
• Store, in the receiver, the new identity code programmed on the transmitter
• Perform a standard association of the transmitter buttons with the receiver relays
as follows :
Button n°1 of the transmitter allocated to the relay n°1 of the receiver,
Button n°2 of the transmitter allocated to the relay n°2 of the receiver,
Button n°3 of the transmitter allocated to the relay n°3 of the receiver,
...etc
This programming procedure erases all the button/relay associations,
interlock functions and operating modes of the previously programmed relays
(only the radio channel setting is preserved).
The « standard » association procedure uses jumpers (or microswitches)
JP1
and
JP3
receiver jumper/microswitches..
) )
) )
)
IMPORTANT
JP1
and
JP3
switches
on ORRD receiver
JP1
and
JP3
jumpers
on ORRA receiver
The receiver is equipped with 3 programming jumpers/microswitches
JP1
,
JP2
and
JP3
and three LEDs with
V1
,
V2
and
V3
which give indication to the
user during programming procedures (
V1
is switched ON continuously when
receiver is powered).
1- Switch off industrial receiver (ORRA or ORRS) , the receiver on DIN rail
(ORRD) can remain power supplied during all the procedure.
2- For the ORRS and ORRA , place jumpers JP1 and JP3 in the short-circuit
position (
JP2
not short-circuited ), for ORRD receiver, set microswitches
JP1
and
JP3
to the «ON» position.
JP1
and
JP3
jumpers
on ORRS receiver