Jasic VIPERMIG 180i, Руководство пользователя

Страница: 22 / 40

2 2
Continued set up of the Spool Gun with Viper 180i
(9) Carefully feed the wire over the drive roller into the outlet guide tube, feed through into the torch neck.
Check that the drive roller being used complies with the wire diameter, replace the roller if necessary.
(10) Align the wire into the groove of the drive roller and release the tension arm making sure the wire is in
the groove of the drive roller.
(11) Apply a n ade quate amount of pressure to the drive roller by winding in the tension adjusting knob,
(12) Adjust spool ho l der tension
(13) Remove the gas nozzle and contact tip from the torch neck, Pull the trigger to drive the wire through
the neck until it exits the contact tip holder
(14) Fit the correct sized contact tip and feed the wire through it, screw the contact tip into the tip holder of
the torch neck and nip it up tightly.
(15) Fit the gas nozzle to the torch head and close the wire spool cover.
(16) Carefully open the gas cylinder valve and set the flow rate to between 2 0-25 cfh.
(17) Set the welding parameters using the wire feed and voltage control knobs.
(9) Carefully feed the wire through the inlet
guide tube onto the drive roller through into
the outlet guide tube. Squeezing the tension
arm adjustment knob to release the pressure
of the tension arm will allow the wire to be
guided through the drive roller easily
(10) Check to make sure that the wire
passes cleanly through the drive roller into
the outlet guide tube.
(14) Fit the contact tip over the wire and
screw it into the tip holder, nip it up tight.
(15) Fit the gas nozzle and close the wire feed
spool cover
(13) Remove the gas nozzle and contact tip.
Pull the trigger to drive the wire through the
neck until it exits the contact tip holder
(11) Apply a medium amount of pressure
using the tension arm adjustment knob.
(17) Set welding parameters using the
voltage and wire feed controls.
(16) Carefully open the valve of the
gas cylinder, set the flow to 2 0 - 25 cfh
(12) Adjust spool hoder tension