Janome Horizon Memory craft 7700 QCP, Инструкция

Страница: 17 / 96

15
Winding the Bobbin
z
Pull the thread from the spool.
Hold the thread with both hands and pass the thread
into the guide slot.
1 Guide slot
x
Draw the thread to the left and forward around the
thread guide.
Draw the thread to the rear and to the right around
under the guide plate.
Firmly pull the thread to the right while holding it
with both hands.
2 Thread guide
3 Guide plate
c
Pass the thread through the hole in the bobbin from
the inside to the outside.
Put the bobbin on the bobbin winder spindle.
Push the bobbin to the right.
4 Hole
v
Hold the free end of the thread in your hand and
start the machine.
Stop the machine when the bobbin has wound
several layers, and cut the thread close to the hole
in the bobbin.
NOTE:
Set the speed control slider at the fastest position.
b
Start the machine again.
Stop the machine when the bobbin is fully wound
and stops spinning.
Return the bobbin winder spindle to its original position.
Remove the bobbin and cut the thread with the thread
cutter.
5 Thread cutter
NOTE:
For safety purposes, the machine will automatically stop
2 minutes after starting bobbin winding.
z
c
x
1
2
3
4
b
v
5