Janome Horizon Memory craft 7700 QCP, Инструкция

Страница: 32 / 96

30
Securing seam
For fastening the ends of seams, press the reverse
button and sew several reverse stitches.
The machine sews in reverse as long as you press and
hold in the reverse button.
Press the reverse button once when sewing the Lock-a-
Matic stitch (pattern D2/D2S) or locking stitch (pattern
D3/D3S) so the machine will lock the stitch off and stop
automatically.
1 Reverse Button
After finishing sewing, press the thread cutter button to
cut the threads.
2 Thread Cutter Button
NOTE:
Use the thread cutter on the face plate to cut the
specialized threads, thick threads #30 or thicker.
3 Thread Cutter
Using the Seam Guides
The seam guides are marked on the needle plate, free
arm and hook cover.
The seam guides for 1/4”, 3/8” and 5/8” are also marked
on the front of the needle plate.
1 Seam guides on the front of the needle plate
The numbers on the needle plate indicate the distance
from the center needle position in millimeters and inches.
2 Center Needle Position
The cornering guides are very useful when turning a
square corner.
3 Cornering guide
The angle scales on the needle plate are useful for
patchwork piecing.
4 Angle scales
Turning a square corner
To maintain a 5/8˝ seam allowance after turning a square
corner, use the cornering guide on the needle plate.
Stop sewing when the front edge of fabric reaches the
cornering guide lines.
Lower the needle by pressing the needle up/down position
button.
Raise the presser foot and turn the fabric 90 degrees.
Lower the presser foot, and begin stitching in the new
direction.
3 Cornering guide
1
3
2
1
4
2
3
3
3
5/8”