Janome 6125QC, Инструкция

Страница: 26 / 43

[4]
[5]
[6] [7]
[8]
[9]
[4]
Draw the needle thread to the left through the hole
on the foot. Place the fabric under the foot and
lower the needle at the starting point of the
buttonhole mark. Then lower the foot.
6.
Needle thread
7.
Bobbin thread
8.
Buttonhole mark
9.
Starting point
NOTE: Make sure there is no gap between the slider
and spring holder, otherwise the left and right
length will be different.
10.
Slider
11.
Spring holder
12.
No gap
13.
Sewing gap
[5]
Depress the foot control to sew a buttonhole.
The machine will stop when the buttonhole is
completed.
[6]
Raise the foot and cut the both needle and bobbin
threads leaving 10 cm (4˝) thread ends. Pull the
bobbin thread to draw the needle thread to the
wrong side of the fabric, and tie them together.
[7]
Remove the fabric and place a pin just before the
bartack to prevent cutting bartack.
Cut the opening with the seam ripper.
14.
Pin
15.
Seam ripper
To repeat buttonhole sewing:
[8]
Select the other pattern and re-select the
buttonhole by turning the pattern selector dial in
either “ 1 ” or “ 2 ” direction to reset for sewing the
next buttonhole.
16.
Pattern selector dial
[9]
After the buttonhole sewing is finished, push the
buttonhole lever upward as far as it will go.
17.
Buttonhole lever
6
7
8
9
10
11
12
13
14
15
16
17
24