www.janitza.de
11
Module 96-PA-RCM / 96-PA-RCM-EL
2.3 Product safety
The device, the components and the modules
reflect current engineering practice and accepted
safety standards, but hazards can arise nonethe-
less.
Observe the safety regulations and warning no-
tices. If notices are disregarded, this can lead to
personal injury and/or damage to the product.
Every type of tampering with or use of this device,
the components or the modules,
·which goes beyond the mechanical, electrical or
other operating limits can lead to personal injury
and/or damage to the product;
·constitutes “misuse” and/or “negligence” under
the product’s warranty and thus voids the war-
ranty for any possible resulting damage.
Read and understand the respective documenta-
tion and user manuals before installation, opera-
tion, maintenance and the use of this device, the
components or the modules.
Only operate the device, components and mod-
ules when they are in perfect condition and in
compliance with this user manual and the as-
sociated, included documents. Send defective
devices, components and modules back to the
manufacturer in compliance with proper transport
conditions.
Retain the user manual throughout the service life
of the device or components and modules and
keep it at hand for consultation.
When using the device, components or modules,
also observe the legal and safety regulations for
your system that are applicable for the respective
use case.
2.4 Hazards when handling the device, com-
ponents and modules
When operating electric devices, certain parts of
these devices can conduct hazardous voltage.
Consequently, material damage and bodily injury
including death can occur if they are not handled
properly.
Therefore, when handling our devices, compo-
nents, and modules, always observe the following:
·Do not exceed the limit values specified in the
user manual and on the rating plate; this must
also be observed during testing and commis-
sioning.
·Take note of the safety and warning notices in all
documents that belong to the device, compo-
nents or modules.
WARNING
Risk of injury due to electrical voltage!
Severe bodily injury or death can result! Therefore
please abide by the following:
·
Switch off your installation before com-
mencing work! Secure it against being
switched on! Check to be sure it is de-en-
ergized! Ground and short circuit! Cover or
block off adjacent live parts!
·
During operation and troubleshooting (espe-
cially with DIN rail devices), check the envi-
ronment for dangerous voltages and switch
these off if necessary!
·
Wear protective clothing and protective
equipment in accordance with applicable
guidelines when working on electrical sys-
tems!
·
Before making connections, ground the de-
vice / component / module by means of the
ground wire connection, if present!
·
Do not touching bare or stripped leads that
are energized! Equip stranded conductors
with wire ferrules!
·
Hazardous voltages can be present in all cir-
cuitry parts that are connected to the power
supply.
·
Protect the supply voltage with a suitable
line circuit breaker/fuse!
·
Never switch off, remove or tamper with
safety devices!
·
There can still be hazardous voltages pres-
ent in the device, components and modules
even after being disconnected from the
supply voltage (capacitor storage).
·
Do not operate equipment with current
transformer circuits when open.
·
Only connect screw terminals with the same
number of poles and design!
·
Do not exceed the limit values specified in
the user manual and on the rating plate; this
must also be observed during testing and
commissioning.
·
Take note of the safety and warning notices
in the documents that belong to the device,
components and modules!
