Jandy APURE35, Инструкция по установке и эксплуатации

Страница: 12 / 36

Page 12
Figure 11. Water Flow Arrows
Figure 13. Locking Ring
Alignment
Figure 17. Attaching Terminal Cap
Figure 14. Locking Ring
Figure 16. Connecting Cell Leads
Figure 12. Cell Attached
Figure 15. Locking Ring Level
10. Verify the gasket is attached to the upper clamp. The curved side of the gasket must be pointing down so that it
will create a seal with the pipe.
11. Secure the clamps, pipe spacer, and gasket around the pipe as shown (see Figure 10) making sure the flow arrows
on the clamp point in the direction of the water flow (see Figure 11). Make sure the two (2) clips on the sides of
the clamp are snapped into place.
12. Insert the o-ring into the channel on the clamp and then attach the cell (see Figure 11 and 12).
13. Position the locking ring in proper alignment, making sure the bump aligns with the top thread (see Figure 13).
14. Screw down the locking ring to the threaded clamp using the locking ring tool (see Figure 14).
NOTE: Ensure the locking ring is level when engaging the threading clamp (see Figure 15) .
15 Securely connect the cell leads to the like colored terminals (see Figure 16).
16. Attach the terminal cap (see Figure 17 ).
Figure 10. Attaching Cell Clamps
Gasket
(Attaches to the upper clamp)
Red
Red
Blue
Black
x
Locking Ring
Tool
Water Flow
O-Ring
Inlet
Outlet
The groove
must be on
the inlet side
Align the bump with
the high thread on
the lower clamp.
NOTE: The Upper
Clamp is not shown
in this diagram but it
should be installed.