J&E Hall JCC2, Техническое руководство

Страница: 21 / 26

Issue: 01.02.2016 Page 21
Technical Information
Electronic Controller (Dixell XR02CX)
To check the setpoint temperature:

Press and release the SET button.
To change the setpoint temperature:

Press the SET button for more than 3 seconds

The setpoint value is displayed and the °C or °F led starts flashing.

To change the setpoint value press the
▲
or
▼
button within 10 seconds.

To retain the new setpoint press the SET button button again or wait 10 seconds.
To start a manual defrost:

Press the defrost button (top left ) for more than 2 seconds.
To lock the buttons:

Press the
▲
and
▼
buttons together for more than 3 seconds. The ‘OF’ message will be displayed and the buttons are now
locked to prevent unauthorized access.
To unlock the buttons:

Press the
▲
and
▼
buttons together for more than 3 seconds. When the ‘ON’ message is displayed the buttons will be
unlocked.
To change a parameter value (selected parameters):

Enter the programming mode by pressing the SET and the
▼
buttons together for more than 3 seconds (°C or °F LED starts
blinking). The first parameter (Hy) is displayed.

Press the SET button to display the parameter value.

Use the
▲
and
▼
buttons to change the parameter value.

Press the SET button to store the new value and move to the next parameter.

To exit the programming mode press the SET and
▲
buttons together or wait 15 seconds without pressing a button.
To enter the hidden parameter menu (full parameter list):

Enter the programming mode by pressing the SET and
▼
buttons together for 3 seconds (°C or °F LED starts blinking).

Release the buttons, and then press the SET and
▼
buttons for more than 7 seconds. L2 will be displayed followed by the
first parameter (Hy). You are now in the hidden menu.

Select the required parameter.

Press the SET button to display the parameter value.

Use the
▲
and
▼
buttons to change the parameter value.

Press the SET button to store the new value and move to the next parameter.

To exit the programming mode press the SET and
▲
buttons together or wait 15 seconds without pressing a button.