J&D MAnufacturing JD-N2, Руководство пользователя

Страница: 25 / 32

JD-N2 USER’S GUIDE
JD-N2 Section C-25
Manual Operation
This parameter is used to override the controller’s calculated demands and
move the curtain in a given direction. If this parameter is set to
Auto
(Auto), the curtain will follow the demand the controller has calculated
according to temperature readings. If this parameter is set to
Hold (Hold),
the curtain will not move. If this parameter is set to
Open
(Open), the
curtain will open continuously. If this parameter is set to Close (Close), the
curtain will close continuously.
Other
Differential Set 1
This parameter sets the relative temperature at which the curtain will follow
it’s timer and either open or close. When
Room Temperature is equal to or
below Target Temperature – Differential , it will close according to Curtain
On Time . When Room Temperature is equal to or above Target
Tempe Differential , it will open according to Curtain On Time .
This parameter is adjusted in 0.1° increments from 0.4°F to 19.9°F (0.2°C to
13.9°C).
Low Temperature alarm set point
Set 2
This parameter sets the temperature below which a low temperature alarm
condition will occur. When the temperature sensor’s reading decreases to
Low Temperature alarm set point or below, the alarm relay and LED will
be activated and the Curtain Idle Time will be overridden. This parameter
is adjusted in 0.1° increments from OFF, 0.1°F to 99.8°F (-17.7°C to
37.7°C).
High Temperature alarm set point
Set 3
This parameter sets the temperature above which a high temperature alarm
condition will occur. When the temperature sensor’s reading increases to
High Temperature alarm set point or above, the alarm relay and LED will
be activated and the Curtain Idle Time will be overridden. This parameter
is adjusted in 0.1° increments from 0.0°F to 99.8°F, OFF (-17.8°C to
37.7°C).
PC ID Set 4
This parameter is used to select the identification number that will be used
when communicating with the remote access software. This parameter may
be adjusted to any value from 1 to 250.
Configuration Version Set 5
This parameter displays the version of the configuration actually used.
Processor Version
Set 6
This parameter displays the version of the processor actually used.