J&D MAnufacturing JD-N2, Руководство пользователя

Страница: 24 / 32

JD-N2 USER’S GUIDE
JD-N2
Section C-24
Parameter Description
Room Temperature
This setting displays the actual room temperature.
Alarm Code Al CODE
This setting displays the alarm condition. This parameter displays
no
(None) when no errors have been detected. This indicates that the
controller has operated properly since it was powered up or since the
Alarm
Code was last cleared. The last alarm condition will be displayed until the
Alarm Code is cleared. To clear the Alarm Code , press and hold the +
and – buttons until Clr (CLr) appears on the LED display. This will
reset the Alarm Code to
no
(None) if no alarm condition is present.
The ALARM LED on the faceplate will be lit up if an alarm condition is
actually active. The alarm code refers to the following table.
Alarm Code List:
Alarm Code Description
1 Sensor has reached Low Alarm Set Point
2 Sensor has reached High Alarm Set Point
3 Sensor is defective or unplugged
101
The controller has reset 10 times and each reset was less
than 15 minutes apart from the last one.
102 If this error code appears, contact your distributor
103 If this error code appears, contact your distributor
Target Temperature
This is the temperature goal for the room and the reference temperature for
all relative settings.
On/Idle Time
Curtain On Time On
This parameter is used to set the run time of the curtain timer. The curtain
will move for this amount of time and then wait for
Curtain Idle Time . This
cycle will be repeated until the curtain receives a continuous opening or
closing demand. This parameter is adjusted in 1-second increments from 1
to 900 seconds.
Curtain Idle Time
Idle
This parameter is used to set the idle time of the curtain timer. After the
curtain has moved, it will wait for this amount of time before moving once
again. This parameter is adjusted in 1-second increments from 1 to 900
seconds.