Getting Started
XT2
User Manual
Janam Technologies LLC Version 3, April 2017
Getting Started 2—2
Charging the Janam XT2 Rugged Touch Computer
BATTERY SAFETY GUIDELINES
The XT2 has a user-accessible, rechargeable battery. Replace only with a Janam-approved battery.
There is the risk of explosion if the battery is replaced by an incorrect type. For more information on
battery replacement see the janam.com website or contact JanamCare at 866-915-5311. Use only
battery chargers approved for the XT2 by Janam. Janam and its affiliates disclaim any liability for
damage caused by the use of other chargers or batteries. Observe the following guidelines for safe
use of Li-Ion batteries:
1. Do not expose the battery to excessive heat or cold. Do not short-circuit. Do not incinerate.
2. To avoid risk of fire, burn or damage to your battery, do not allow a metal object to touch
battery contacts.
3. Do not disassemble the battery. There are no user serviceable parts inside.
4. If battery leakage is observed, avoid any contact with affected area and properly dispose
of the battery.
5. If you come in contact with battery leakage, rinse exposed area with soap and water.
If it contacts the eye, flush the eye with water for 15 minutes and seek medical attention.
6. Dispose of used battery promptly. Keep away from children. Do not disassemble or
dispose of in fire.
7. When discarding a battery, contact your local waste disposal provider to understand
local restrictions for disposal or recycling of batteries.
BATTERY CHARGER SAFETY GUIDELINES
1. Do not use the equipment in or near areas in which sparks are likely or possible.
2. Do not let equipment’s metal contacts and electrical sockets come in contact with metal objects.
3. For indoor use only. Do not expose the equipment to rain or any liquids.
4. Do not use or store the equipment in direct sunlight or in areas that are prone to get hot
such as in a parked vehicle, near a heat duct or close to other heat sources.
5. Keep equipment’s metal contacts and electrical sockets free from debris that could
obstruct charging or could cause a short circuit.
Installing the XT2 battery
To install or replace the XT2
battery, remove the battery
compartment cover on the back
of the unit by sliding the spring-
loaded cover lock to the left,
holding it in that position, and
then gently pulling the cover up
by the two tabs on the left and
right of the cover.
