Jakka Control Kit 4, Руководство пользователя

Страница: 14 / 31

Manual
JAKKA Control Kit 4
13
www.jakkagroup.com
3.1.1 LCD functions
3.1.2 24h clock
The remote control has an integrated 24h clock which is factory set at UTC+2 time. The internal
battery supplies the clock when the remote is not connected.
Change time
 Press OK button for 3 seconds, time starts blinking
 Change time with buttons. Time starts to change faster are pressed for a while.
 Press OK to confirm, current day starts blinking
 Change day with buttons.
 Press OK to confirm
Press RUN/STOP to stop immediately and go back to normal operation
MODE
FAN
COOL
HEAT
AUTO
VOD
EXHAUST FAN SUPPLY FAN
MON TUE WED THU FRI SAT SUN
SET
12.00
25
º C
SET TEMP
BY – PASS
FUNCTION FILTER
CHECK
FAN
HIGH
MED
LOW
Sho ws active mode
of op eration
Shows actual fan speed of
supply and exhaust fan Lights up when By-
Pass is open Lights up when filters
should be checked
Only visible when
changing fan speed
Shows
current day Actual time or
timer blocks Actual room temp
or set point
When blinking
Timer is active
3.1.3 Timer function
The timer function can be used to program block times in which the unit is operating. Outside the
blocks the unit is off.
The timer function makes it possible to program 2 on/off times per day.
Program Timer Blocks
 Press TIMER button for 3 seconds, day MON starts blinking, all other LCD segments are
off
 Press DAY button (one or more times) to select the day to be set
 Press OK to confirm, the selected day is permanent on

The temp display shows which means timer block 1 “on” time can be programmed

Adjust the “on” time with the DAY and SCHEDULE buttons, press OK to confirm
 Next the timer block 1 “off” time can be programmed, the temp display shows
 Again adjust the “off” time with the DAY and SCHEDULE buttons, press OK to confirm
 Next the timer block 2 “on” time can be programmed, the temp display shows
 Adjust the “on” time with the DAY and SCHEDULE buttons, press OK to confirm
 The temp display shows which means timer block 2 “off” time can be programmed

Again adjust the “off” time with the DAY and SCHEDULE buttons, press OK to confirm

Now the next day starts blinking and can be programmed accordingly as described above.
 To exit the programming mode press OK for 3 second or wait 1 minute