JAKKA Control Kit 4
Manual
www.jakkagroup.com
12
3
Remote Control
The buttons and display have a short description. In the further paragraphs an explanation of LCD screen, Timer function
and Errors are described.
RUN/STOP
When the backlight and led is off, press the button once to turn the unit on.
When the unit is “on” press RUN/STOP 2 seconds to switch it off.
The button can be pushed to turn the Remote Control on. Button doesn’t react if BMS is active. All
others buttons work if the on RUN led on or timer mode is active. Then the LCD is blinking the word
‘mode’ in left upper corner.
Increase/decrease set point room temperature (SET TEMP is on)
MODE
Press to select the listed modes of operation (FAN, COOL, HEAT, AUTO, VOD). Every time a button
is pressed a next mode lights up. After a 5 seconds delay the mode will be activated. The text MODE on
display is always visible.
FAN SPEED
With this button the fan speed of the exhaust and supply fan can be changed.
Pressing once: text FAN lights up. “EXHAUST FAN” and current fan
speed (text) starts blinking
Use
buttons to select fan speed (high, med, low)
Press OK to confirm
“SUPPLY FAN” and current fan speed (text) starts blinking
Use
buttons to select fan speed (high, med, low)
Press OK to confirm
MODE
FAN
COOL
HEAT
AUTO
VOD
FAN
HIGH
MED
LOW
EXHAUST FAN SUPPLY FAN
MON TUE WED THU FRI SAT
SET
12.00
25
º
C
SET TEMP
BY –
PASS
FILTER
CHECK
RUN/STOP
MODE
HRV
SELECT
FAN SPEED
TIMER
RESET
DAY
SCHEDULE
OK
HRV
TIMER
Bypass on when possible
Press 3 seconds to SET the timer function.
TIMER +
MODE
Press 2 seconds both buttons the timer is now active. The display shows
‘MODE’ is blinking in de left upper corner.
TIMER +
Press 2 seconds both buttons the timer is now active. The display shows
FAN SPEED
‘addr’ is showing in time position, on position temp the address of Modbus is
showing. ‘- -‘ means the display is retrieving the Modbus address.
RESET
Press to reset filter check when display shows FILTER CHECK.