DCF-S-0126-2
Japan Aviation Electronics Industry, Ltd.
Connector Div. Production Engineering Dept.
日本航空電子工業株式会社コネクタ事業部生産技術部
Number
番号
T700316
Page
9
/
11
JAE Connector Div. Proprietary.
Copyright (C) 2011, Japan Aviation Electronics Industry, Ltd.
6.製品チェック
6.CHECK OF CRIMPED CONTACTS
本項では、圧着コンタクトの良品について説明
します。
This paragraph provides criteria of discrimination
between “Proper “crimped contacts after crimping
operation.
正しく圧着されたコンタクト
PROPER
CRIMPED
CONTACT
(1)
クリンプハイトが、電線サイズによる指定寸法内で
ある。(
2
項参照)
(1)
Crimp height is satisfied with crimp
standard.(refer to para.2)
(2)
芯線先端が芯線バレルより出ていること。
(2)
Wire strands tip is extended from the wire
barrel.
(3)
芯線バレル内に被覆が喰い込んでいないこと。
(3)
Wire insulation does not intrude into the wire
barrel.
(4)
芯線がバレルからはみだしていないこと。
(4)
Wire strands do not protrude between the
wire barrel and the insulation barrel.
(5)
被覆バレル内に被覆が巻かれていること。
(5)
Wire insulation is wrapped in the insulation
barrel.
(6)
ベルマウス(芯線未圧着部)があること。
(6)
Bell-mouth (not crimped part)is formed.
(7)
圧着面が過度に荒れていないこと。
(7)
Crimped surface is not got too rough.
(8)
その他コネクタ製品仕様を満足していること。
(8)
Crimped contact is satisfied with other
specifications of connector product.
注意事項
NOTE
※
本項に記載されているものは、一般的な良否基準
です。その他詳細につきましては、
ES5
シリーズコ
ネクタ取扱説明書
JAHL-10805
を参照下さい。
※
This paragraph is a general quality standard.
For product check other than crimping, refer to
ES5 Series connector assemble manual
No.JAHL-10805.
注意
CAUTION
クリンプハイトは、クリンプハイト専用
のマイクロメータを使用し、右図のよ
うに測定してください。
Use the micrometer for the crimp
height to measure the crimp
height.
クリンプハイト
Crimp
height
中央付近
Nearly the center of barrel