11/29
ATTENTION!
Do not over-tighten any parts.
5. Operating the equipment
ATTENTION!
Do not operate your equipment if parts are missing.
Replace any defective parts before use.
Misusing the
equipment can result in malfunction and personal injury.
hose clamp
delivery tube
hose
tank outlet
lock pin
Spreader
handle
articulation
assembly
cotter pins
fairing
cotter pins
washers
1)
1)
2)
2)
clamp
hose
• Insert the hose through the clamp, fit it into the tank outlet, and tighten the
clamp.
• Insert the other end of the hose through the fairing and screw it back onto
the tank.
• Then, insert the hose through the clamp into the
delivery tube
and tighten
the clamp.
ATTENTION!
When operating the spreader, wear personal protective
equipment (PPE), such as boots, gloves, protective
eyewear, and a face mask.
1)
1)
2)
2)
• Remove the tank fairing;
4.2. Adjusting the strap
The equipment tank has an anatomical shape, providing greater comfort to the
operator. With a simple strap adjustment, the operator can position the equip-
ment correctly on his back.
• Pull the straps down to adjust them as needed.
B
pull strap
down
strap lock
A
• Fit the spreader handle into the articulation assembly using the cotter pins
and washers from the assembly kit.
• Then fit the lock pin and cotter pins as shown below;
OBS.: Jacto GT-18 tank is sold separately.
4.1. Assembly
Follow the steps below to assemble Jacto GM-12 granular spreader.
