Installation of Model 24LM Top and Table gasket:
These instructions are to be used for applying the adhesive backed sponge rubber strip to the top of the machine
prior to setting the table in place.
Included with the Model 24LM table is a 6' length of 1/
4"
thick x 1" wide sponge rubber adhesive
backed stripping.
Instructions for applying gasket:
1. Place one end of the stripping along the complete side
of leg support flange and cut it off.
2. Repeat the same procedure along the other side.
3. Place the remaining piece along the front edge and fit it
in between the side pieces and cut it to length.
4. Remove the backing and set the strips in place
Installation of Model 24LM Dishwasher Under Dishtable:
1. On the end of the table, locate bracket #4 opposite the sink end.
2. A rubber gasket #3 is supplied and should be secured to top frame of dishwasher.
3. Place dishtable #2 where it is to be installed and support the machine's end.
4. Slide dishwasher #1 underneath dishtable #2 so that the outside of machine is positioned against the
guide bracket #4. Make sure dishtable and dishwasher are in desired permanent location.
5. Using the two holes in bracket #4 as a guide, drill two holes 9/64" diameter in the side panel of machine.
Note: Drill through first thickness of metal only.
6. Using the self-tapping screws supplied, screw them through bracket #4 and into the side panel of
machine until screws are tight.
