INSTALLATION OF TIE DOWN ASSEMBLY FOR CANADIAN STANDARDS
1. Locate the desired floor area in which the unit is going to be installed.
2. Place the base cradle in the exact location the machine will set with the end having the holes drilled in it
to the rear.
3. Mark the holes and then drill two holes 3/8" in diameter, approximately 1-1/2" into the floor, no deeper.
4. Clean any debris out of the holes and place the sleeve anchors with the bolts into the hole. Press them
down and then tighten the nut down so that the anchor fastens firmly into the floor. Back off the nut and
remove it so that approximately 1/2" to 3/4" of the bolt is now a stud sticking up from the level of the
floor.
5. Lay the cradle in place over the studs and seal around the cradle with a silicone rubber sealant.
6. Attach the back panel to the machine by sliding it between the rinse water line and the unit, then
fastening it at the bottom corners to the machine. When the back panel is in place attach the anchoring
bracket loosely to the panel using the elongated slots.
7. Pick the machine up and set it into place on the base cradle. Make sure that the studs through the base
cradle are inserted into the holes in the bottom of the anchoring bracket.
8. Remove the lower front kick panel and level the machine trying to have It a 1/4" higher in the front than
in the back.
9. Once the unit is level fasten the nuts over the studs and tighten to the floor. Next
fasten the bolts and nuts that attach the anchoring bolts to the back panel.
10. When the unit is tightened down and securely in place the remainder of the installation can continue.
1. BASE CRADLE
2. ANCHORING BRACKET
3. RINSE WATER LINE
4. BACK PANEL
5. ELECTRICAL CONNECTION CUT
OUT
6. INCOMING WATER CONNECTION
PUT OUT
