GENERAL INSTRUCTIONS
(INSTALLATION)
Note: Read the following instructions carefully. Proper installation of your Jackson Dishwasher
will assure proper machine operation.
Uncrating 24L:
1. Remove straps around carton.
2. Open top flaps of dishwasher carton.
3. Remove any packing from top and sides of machine that can be done with ease from top.
4. Slide carton sleeve upward over top of dishwasher, set to one side.
5. Lift dishwasher and wooden base from carton base.
6. Move dishwasher to general installation area.
7. Remove bolts holding wooden base to machine and screw in adjustable feet supplied.
8. Reassemble wash and rinse assemblies in machine using sketch and instructions in this manual.
9. Set dishwasher in place, ready for installation.
Note: NSF base cradle installation must be field installed on all LF and BF models. Cradle Is sealed to
floor with waterproof caulking or equal and dishwasher feet are set inside and on cradle.
Installation Instructions:
1. The unit must be installed a
1/4"
higher in the front than in the back. It should not be level but higher in the front
to allow more water in the back of the tank.
2. Refer to dimensional data sketch for connections.
3. The drain from the machine is a gravity drain system and should, therefore, have the proper drop from the
machine to the kitchen's drain system. The drain connection is located to the left rear of the machine when
facing the machine's door. The drain fitting is 1-1/2" OD tube size.
7"
from floor.
4. The incoming water line should be attached to the machine's connection which is located to the front left side of
the machine. The pipe size to the machine should be 1/2" and the water should be 120° - 140°F with a flow
pressure of 20 PSI.
5. The electrical connections should be made to the terminal board located at the left center front. The terminals
are marked L1, and L2. Install proper circuit breaker, wire and conduit size to conform with local and/or national
codes (standards).
6. Located behind the control panel and lower kick plate on the left side of the unit is the sanitizer pump and intake
tubing. Shipped with the machine is a 12" piece of gray PVC that is a tube stiffener for the white pump tubing.
Unroll the white tubing from the unit and push it through the slotted end of the stiffener until it is even with the
very tip of the angled end. Place your sanitizing agent bottle next to the machine and insert the tube stiffener
into the bottle.
DIMENSIONAL DATA
Reference only
Subject to change
LEGEND
A—ELECTRICAL HOOK UP
B—1/2"
F.S.P.S.
WATER INLET
C—1
1/2"
DRAIN
CONNECTION
D—SANITIZER PUMP
