![background image](http://html1.mh-extra.com/html/jabiru/j120/j120_technical-manual_3130523146.webp)
Aircraft Service Manual
Jabiru Aircraft
Pty Ltd
JTM001-1
J120, J160, J170, J200/J400, J230/J430, J250/J450 Variants
REVISION
1
Dated: Nov 2011
Issued By: SW
Page: 146 of 233
11.7.4 INSPECTION & REPAIR
Visually inspect for excess wear or contamination of the lubron block.
If required, apply fresh graphite lubricant
Inspect the pivot bearings for condition and replace if required.
Inspect hardware for damage or corrosion.
11.7.5 INSTALLATION
Reverse the removal procedure above for installation.
WARNING
All spherical rod end bearings must be fitted with a large washer on the outside of the through-
bolt to prevent the bearing case and cable releasing in the event of a bearing failure.
Figure 119
– Trim Controls – At Tail
11.8 TRIM CONTROL CABLES
11.8.1 DESCRIPTION
Control Cables are of the enclosed push-pull type, fitted with spherical bearings at both ends. To
operate, the outer cover of the cable must be clamped firmly at each end.
11.8.2 CONTROL CABLE REMOVAL
1.
Unbolt the connections (rod end bearings) at either ends of the cable.
2.
Unbolt the clamps at either end of the cable.