![background image](http://html1.mh-extra.com/html/jabiru/2200/2200_instruction-and-maintenance-manual_3119579054.webp)
Jabiru Aircraft
Pty Ltd
Instruction & Maintenance Manual
Jabiru 2200 Aircraft Engine
Hydraulic Valve Lifter Models
This document is controlled while it remains on the Jabiru server. Once this no longer applies the document becomes uncontrolled.
REVISION
0
1
2
3
4
5
6 7
8
9
Dated : June 2010
Issued By: DPS
Page: 54 of 116
L:\files\Manuals_For_Products\Engine_Manuals\Transition\JEM2204-9_I&M_unsigned.docx
Figure 22. Drawing 9434064
– Piston Diameter
5. Clean inhibitor off new rings.
6. Measure end gap of rings in the cylinder and record in build sheet.
7. Fit rings with dots up
Note: End of oil ring expanded must be butted together. Piston rings orientated
with joins opposite and not in thrust line.
8. Fit pistons in cylinders. Oil Ring should only just enter so piston pin can be
fitted later.
Note: Arrows on inside of pistons point in direction of rotation. Oil Rings and
pistons and bore well. Notch on the piston crown faces the Propeller Flange.
9. Fit front piston pin circlip.
10. Fit cylinder base O Ring.
11. Seal up in plastic bags ready for final assembly.
7.5.1.5
Sub-Assembly D - Sump and Oil Pump
Sump
D1
1. Clean sump and remove all gasket eliminator.
2. Inspect oil pick up.
D2
1. Remove & disassemble swept plenum
D3
Inspect carburettor coupling replace if it is damaged or showing signs of
deterioration.
Note: It is very important that the carburettor and coupling are free of oil. If there
is any oil present at all, it is possible for the carburettor to slip out of the coupling.
This can also happen if the clamp is not positioned to the rubber edge facing the
carby
D4
Fit new induction O Rings to Induction Pipes
Oil Pump
D5
1. Inspect oil pump inner and outer for damage to rotor surfaces
2. Measure rotor clearance