J.Sikora – Standard MAX Turntable Manual
8
© 2021 Notable Audio Products | www.notableaudio.com
II. Setting Up Your Table
Before assembly, be sure that the rack and shelf are level. Carefully check each direction with a spirit level.
The turntable does have leveling adjustments, but it is always better to make the major leveling adjustments
to the rack and then perform only the fine leveling with the turntable’s feet. It is far easier to adjust your
rack without a heavy turntable on it.
1.
Set the Isolation Base
The Isolation Base provides an extra level of isolation. In this step, you will configure and level the
Isolation Base.
1.1.
Place the Isolation Base
The Isolation Base is heavy, so if you
place it directly on your shelf, it may
scratch the shelf.
Isolation Base with Built-In Controller
Put 3 of the included leather J.Sikora
Coasters (cardboard for non-North
American customers) under the Feet of
the Chassis during the setup process to
avoid damaging the shelf.
J.Sikora Coasters
Note where the points of the Isolation
Base’s Feet are located. There are two
Feet on the bottom of one side of the
Isolation Base and one Foot on the other
side.
Underside of Isolation Base
Place the Coasters in the approximate
position where you would like the Feet
to sit.
With the help of another person, slowly
lower the Isolation Base onto the
Coasters. Once on the Coasters, gently
slide the Isolation Base to where you
would like to use your table.
Isolation Base on Coasters
Adjustable
Feet
Warning! We strongly suggest getting help from a second person to set up your J.Sikora turntable. The
turntable is extremely heavy.
