J.Sikora – Standard MAX Turntable Manual
28
© 2021 Notable Audio Products | www.notableaudio.com
13.
Connect the Motors and Power Supply
In this step, you will plug the Motors into the bank of power jacks on the back left corner of the Isolation
Base.
13.1.
Connect Power Supply Cable
Plug the barrel connector at the end of
the Power Supply cable into the Power
Jack.
The location of the Power Supply in the
above image is only intended to allow
you to see the connection. For your
setup, the Power Supply should be
located away from the table so you
don’t induce any hum.
Attach Power Supply Umbilical Cable
13.2.
Connect Motor Cables
The connector on the DIN plug of the
Motors’ Umbilical Cables can only fit
one way. You must align the guide pin
on the Umbilical Cable with the guide
groove cut-out on the Motor Power
Jack. Do not force the connection.
Alignment of Motor Cable
Power and Motor Cables Connected
Alignment
Notch
Alignment
Pin
