J.Sikora – Standard MAX Turntable Manual
42
© 2021 Notable Audio Products | www.notableaudio.com
3.
Starting / Stopping the Turntable
Start and stop the turntable via the
Control Unit that is integrated inside the
Isolation Base. To start the turntable,
press either the 33 or 45 RPM Speed
Selector Button. To stop the turntable,
press the OFF Button.
Start / Stop Buttons
4.
Adjusting the Speed
Your Speed Controller allows you to
finely tune the speed of the Platter’s
rotation. Because of the significant
weight of the Clamp, place the Clamp
on the platter before adjusting the
speed.
Use your favorite speed accuracy tool
(not supplied) to test the speed of the
turntable at 33 1/3 RPM. To do this,
press the 33 RPM button to power on
the table and wait 10 seconds for the
turntable to come up to speed and
stabilize. To increase the speed, press
the “+” button. Likewise, press the “-” to
decrease the speed. Once you have set
the speed accurately, press the 33 RPM
button once again to save the setting.
Follow the same procedure to set the 45
RPM speed.
Speed Control Buttons
5.
Getting Your Turntable Settled
Once you have set up your Turntable, it needs a few days of playing to fully settle in. Once the oil
spreads, you will not need to re-oil it for several years. The Drive belts also need a few days to stretch to
the optimum length and tension. During this settling-in period, the speed may vary slightly. If the speed
changes, you can adjust it accordingly. Check the speed after a few days of use and then again in a
month or so.
On Button
for 33 1/3 LPs
On button
For 45s
Off
Button
Decrease
Speed
Button
Increase
Speed
Button
