IWILL MPX2, Руководство пользователя, Страница: 87 / 106

6: Using The Motherboard
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
User’s Manual 6•3
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Indicator LEDs
The motherboard front panel features connector supports
three system status indicator LEDs:
• Power Status LED Indicator
Lights when the system is turned on.
• Hard Disk Drive Activity LED Indicator
Flashes during hard disk drive access.
• Power Conservation Mode LED Indicator
Lights to indicate the system is in a Suspend state
power conservation mode.
Most system housings will have all of these LEDs mounted
in the housing’s front panel.
Wake Up Features
There are two system wake up features, Wake On LAN
and Wake On Ring. These are set to Diabled by default in
the WakeUp Event Control subsection of the Power Man-
agement section of the CMOS Setup Utility. You must set
the RI Event/WOL line to Enabled to use these features.
Wake On LAN (WOL)
Function: The system wakes up in response to a signal
arriving over a LAN that it is connected to.
Use: The onboard WOL connector supports connection
to a PCI Network Interface Card. The WOL cable from
the card connects to the WOL connector on the board.
Wake On Ring(WOR)
Function: The system wakes up in response to a “ring
in” signal from a telephone line an internal modem is
connected to.
Use: The onboard WOR connector supports connection
to an internal PCI modem card. The WOR cable from the
modem card connects to the WOR connector on the board.