IWILL MPX2, Руководство пользователя, Страница: 47 / 106

4: Installing The Motherboard
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
User’s Manual 4•3
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Installing The Processor
Installing a processor in the Socket 462 is a simple proce-
dure. It is very important, however, to carefully handle
the processor by the edges and always fully observe pre-
cautions against electrostatic discharge. We assume here
that you are installing a “boxed” processor, that is, one
packaged by AMD and sold retail. If you are installing a
non-boxed processor, the procedure is the same, but the
accessory items may have a different appearance.
Please follow the installation procedure as illustrated on
the next two pages. The illustrations are generic and do
not specifically represent this motherboard.
The processor installation procedure is as follows:
Raise the socket lever to the
vertical position
Step 1:
Raise the retaining lever
Two corners have pins
missing on the socket
and the processor
Step 2:
Align the CPU so that the
two corners with missing
pins match the corre-
sponding receptacles in
the socket.
Note:
All supported CPUs install
the same way.
Important:
If you install a CPU that
has a 200MHz FSB speed,
you must set jumper JP5
to the 100MHz setting.
See Chapter 3.
2. Align the processor to the socket by matching the
beveled Pin 1 corner of the CPU to the Pin 1 corner
on the socket, which is located at the corner where
the locking arm attaches to the socket.
1. Raise the locking lever of the processor locking
mechanism to a perpendicular position.
Important:
Remove the protective
cover from the CPU socket
before installing a CPU.