ITT Goulds Pumps V 3298, Инструкции по установке, эксплуатации и обслуживанию

Страница: 132 / 148

2. Spread bottom of coupling guard half (pump end)
slightly and place over pump end plate as shown in
Fig. II-4. The annular groove in the guard half is
located around the end plate (Fig. II-5).
3. After the coupling guard half (pump end) is located
around the end plate, secure it with a bolt, nut and
two washers through the round hole at the front end
of the guard half as shown in Fig. II-6. Tighten
securely (Fig. II-7).
4. Spread bottom of coupling guard half (driver end)
slightly and place over coupling guard half (pump
end) so that annular groove in coupling guard half
(driver end) faces the motor as shown in Fig. II-8.
132
3298 Family Rev. 4/07
Fig. II-4
Fig. II-5
Fig. II-6
Fig. II-7
Fig. II-8