ITT Goulds Pumps V 3298, Инструкции по установке, эксплуатации и обслуживанию

Страница: 17 / 148

FEATURE FABRICATED STEEL/
API STYLE
(BASEPLATES PROVIDED WITH VERTICAL
LEVELING ADJUSTORS)
1. Coat the jack screws with an anti-seizing compound to
allow for easy removal after the grout has been cured.
2. Cut round circular plates from bar stock to set the jack
screws on. The edges of the plates should be
chamfered to reduce stress concentrations.
3. Set the baseplate on the foundation and use the four
corner jack screws to raise the baseplate off the
foundation 0.75" to 1.5" (Fig. 14). The two center jack
screws should not be touching the foundation.
4. Place two machinist levels on the motor pads, one
lengthwise on a single motor pad, and another across the
ends of both motor pads (Fig 15).
NOTE: When using a machinist level, it is important
that the surface being leveled is free of all
contaminants, such as dust, to ensure an accurate
reading.
5. Level the motor pads as close to zero as possible, in
both directions, by adjusting the four jack screws.
6. Next, turn down the center jack screws so that they are
resting on their metal discs on the foundation.
7. Place the two levels on the pump pads, one lengthwise
on a single pump pad, and another across the middle of
both pump pads. (Fig. 16)
8. Level the pump pads as close to zero as possible, in
both directions, by adjusting the jack screws.
9. Install the anchor bolts until they are hand tight.
10. Return the levels to the motor pads and check the level
measurements.
11. Adjust the jack screws and anchor bolts, if necessary,
until all level measurements are within the design
requirements of 0.002 in./ft.
12. When taking readings, center the level over the pad
being measured.
NOTE: The Baseplate Leveling Worksheet provided
may be used when taking readings.
3298 Family Rev. 4/07
17
3
Fig. 14
Fig. 15
Fig. 16