Itm ITM 800, Инструкция по эксплуатации

Страница: 86 / 118

Maintenance and adjustment 80
4
the axle to be greased off the ground
with a jack.
4. Turn the wheel by hand so that both the
greasers are visible, grease from the
front of the tractor.
5. Repeat the operation for the other side
of the axle and replace the stop pins.
Front wheel hubs (Fig. 49)
Check the front hub adjustment
every 500 hours.
Fig.49: Front hub filler plug.
2
1
If the front hub requires adjustment,
proceed as follows:
1. Raise the wheel off the ground and re-
move the hub cap.
2. Remove the split pin (1) and tighten
the castellated nut (2) to a torque of
80 Nm (60 lbf ft), then slacken off the
nut to the nearest pin hole to give the
correct end float. Fit a new split pin.
3. Refit the hub cap. Grease the hub until
clean grease comes out past the seals
at the back of the wheel.
Cab windscreen washer (Fig. 50)
Check windscreen washer bottle -
Flexible maintenance.
Fig. 50:
The capacity of the washer bottle is
about 2 litre (3 1/2 pt). Fill with a screen
washer additive to prevent smearing and
freezing in cold weather. The angle of the
windscreen washer jets (located below the
windscreen) may be adjusted by inserting
a needle into the jet orifices and moving,
as required.
Cab air filter
Remove and clean the cab air filter
- Flexible maintenance (Fig. 51 and 52).
Fig. 51:
1
2
Remove the bolts (1 Fig. 51 and 4 Fig.
52) covers (2 Fig. 51 and 3 Fig. 52) ,clean
the filter by carefully tapping it on the
palm of the hand, then direct compressed