Itm ITM 800, Инструкция по эксплуатации

Страница: 19 / 118

1
General information
13
If the doors are obstructed, leave the
cab through the rear window or hatch.
When making in-work adjustments,
bring the tractor to a secure halt, apply the
parking brake, disengage the PTO, select
neutral gearshift positions, lower the im-
plement to the ground, stop the engine and
remove the key BEFORE leaving the seat.
When adjustments are being made or
attachments are being fitted to the tractor
or implement (whether at the front or rear
of the tractor), the operator must ensure
that all persons are well clear before op-
tem by shorting across the terminals of
the starter motor to start the engine. This
may cause the tractor to move suddenly. If
the starter switch does not work, consult
ITMCO Dealer.
Ensure that all bystanders, particu-
larly children, are in a safe position before
starting the engine.
Safety — during operation
Keep a firm grip on the steering wheel
at all times, with the thumbs clear of the
spokes when driving the tractor.
When a cab or ROPS is fitted, if the
tractor overturns, hold the steering wheel
firmly and do not attempt to leave the seat
until the tractor has come to rest.
erating the hydraulics.
Use caution on hillsides and rough
ground
Keep speed to a minimum.
Avoid sudden uphill turns on steep
slopes.
Always keeps the tractor in gear to
provide engine braking when going down-
hill.
Avoid sudden or heavy brake applica-
tions when operating in wet, muddy or icy
ground conditions or on loose surfaces
such as sand or gravel.
Warning
DO NOT pull anything using the top link
connection, or from any point above the
centre line of the rear axle. Always use an
approved Massey-Ferguson drawbar, and
only use a drawbar pin that locks in place.
Warning
DO NOT get on or off a moving tractor.
Fig. 22: Performance of driver when over-
turning
Fig. 23: Driving on steep slopes