Itho Daalderop WPU 5G 25 c, Руководство пользователя

Страница: 24 / 50

7. Ventilation
7.1. Wireless connection
In order to control your Itho Daalderop ventilation system
via the thermostat, you first need to connect the
ventilation unit wirelessly (RF) to the thermostat.
Follow the instructions as described in this chapter.
If the thermostat is connected to the heat pump with a
wired OpenTherm
®
, the TEMPERATURE symbol will not be
visible in the pairing procedure.
7.1.1. Pair VENTILATION UNIT to
THERMOSTAT
ä
Caution!
Only a Itho Daalderop ventilation unit is suitable for
wireless (RF) connection to the thermostat.
Connect the thermostat to the ventilation unit as follows:
a) Put the ventilation unit in pairing mode as described
in the ventilation unit manual.
Make sure that a pairing signal is sent by the thermostat
within 2 minutes. If the pairing fails, the procedure must be
restarted.
b) The thermostat's pairing procedure can only be
started within 2 minutes of the batteries being placed
in the thermostat.
If necessary, install the batteries again!
c) Activate the thermostat within two minutes, press
the
LOGO and hold it down (about 5 seconds) until the
VENTILATION, TEMPERATURE and HOUSE symbols
are displayed on the screen.
Flashing symbols/parts can be paired.
Continuously lit symbols/parts can be unpaired.
To stop, press the LOGO . If no choice is made, the
thermostat will return to operating status after 1 minute.
d) Press the flashing VENTILATION symbol.
The symbol will light up continuously and the
remaining symbols will disappear.
e) Confirm the choice by pressing the LOGO .
24