itema PROMATECH LEONARDO SILVER HI DRIVE 7000, Руководство пользователя

Страница: 26 / 33

01 - 10 - 2004
Console user manual
23
D. Information codes
Information messages with a numerical code may appear for certain malfunctions. These codes
can help the operator understand what caused the malfunction.
D.1 Reset failed code x
The green lamp keeps on flashing every time the reset fails. At this point you can only turn the
loom very slowly in slow motion to resolve certain conditions (e.g. to extract the rapiers from the
shed).
The first time you start the loom up after a software upgrade, the reset may fail 1 or 2 times: in
which case you should switch the loom off and then back on again, and then repeat the reset
procedure.
Code Description
1
No coherence between motor encoder and main loom encoder – Switch off and
then back on again
2
Unaccepted motor status before starting a movement
3
Internal error 03
4
Movement timeout
5
Movement stop timeout
6
Operation aborted due to a power fail
7
Drive not enabled – Check enabling circuit
8
General emergency active (e.g. the mushroom button has been pressed) before
starting a movement
9
Photocells in emergency mode before starting a movement
10
General emergency active (e.g. the mushroom button has been pressed) during a
movement
11
Photocells in emergency mode during a movement
12
Internal error 12
13
Movement interrupted by coherence sensors (rapiers in shed when shed closed)
51
Rapier/reed sensor not found
52
Rapiers in shed when shed closed: movement start not possible – Extract rapiers
from shed (also by jogging in slow motion)
53
Start reset not allowed because loom in emergency mode
54
Timeout (max 60 seconds) for finding rapier/reed sensors with reverse movement
55
Timeout (max 60 seconds) for finding rapier/reed sensors with forwards movement
56
Timeout (max 5 seconds) for second attempt to find rapier/reed sensor
57
Second attempt to find rapier/reed sensor failed due to no sensor consensus
58
Release to find main encoder zero has failed
59
Internal error 59
60
Coupling after main encoder zero search has failed
61
Internal error 61