1. Confirm that the switch of the AC power distribution box is off.
2. Confirm that the power switch is in the OFF position and verify that there
is no dangerous voltage on the connection terminals.
3. Remove the protective cover outside the AC input terminal on the rear
panel.
4. Connect one end of the power cable’s round terminal to the AC power in-
put terminal on the instrument’s rear panel.
a. You only need to connect the red/green/yellow (or brown/black/gray)
live wires to the terminals on the rear panel, which are not required to
correspond to L1, L2 and L3 terminals one by one.
b. The yellow-green wire is grounding wire, which is connected to the
protective grounding terminal (PE).
5. Mount the protective cover back to its original position.
6. Refer to the suggestion connection diagram, connect the other end of the
power cable to the required AC distribution box.
•
The 6U model comes standard with two 3U model power cords, which need
to be connected to the AC distribution box respectively, and the AC input ter-
minals of both need to be connected;
•
For models that have been assembled into a cabinet at the factory, users
need to connect one end of the power cord to the cabinet and the other end
to the distribution box. Refer to the following steps to connect the power
cord;
1. Confirm that the switch of the AC power distribution box is off.
2. Confirm that the power switch is in the OFF position and verify that there
is no dangerous voltage on the connection terminals.
3. Remove the panel of the AC input at the back of the cabinet.
4. Pass the power cord through the lead hole of the panel and connect it to
the branch terminal in the cabinet (from left to right, L1, L2, L3, PE).
a. The three color line wires of red/green/yellow (or brown/black/gray)
correspond to L1, L2, and L3 respectively. Use an internal hexagonal
wrench to loosen the screw of the branch terminal, and then tighten it
after connecting the AC input cable.
b. The yellow-green wire is grounding wire, which is connected to the
protective grounding terminal (PE).
5. Install the panel back in place.
6. Refer to the suggestion connection diagram, connect the other end of the
power cable to the required AC distribution box.
Copyright © Itech Electronic Co., Ltd.
31
Содержание IT6000B Series
