ITC STS10, Руководство оператора

Страница: 6 / 22

FRANÇAIS
ENGLISH
ENGLISH
FRANÇAIS
6
FRANÇAIS
ENGLISH
ENGLISH
FRANÇAIS
TANK
Slide the Water tank ( D in Functional Description, above ) through the slot in
the machine frame so that the entire tank rests inside the machine frame.
MOTOR
1. Mount the Motor (
M in Functional Description, above
) to the machine frame
by connecting the supporting frame to the machine frame at the point shown
in the Schematic Drawing on page 28.
2. Secure using two Bolt s ( Item No.1 ), Split ring lock washer s ( Item No.2 )
and Flat washer s (
Item No.3
) as shown.
BLADE GUARD
1. Attach the blade guard to the motor using the locking knob and flat washer
provided.
2. Please see the following section, “Changing/installing the Blade,” for
instructions on how to properly install a new blade.
PUMP
1. Plug the pump into the marked socket on the left side of the switch box.
NOTE: This receptacle is for the pump only.
The pump is equipped with grounding-type attachment plug, and must be
connected to a properly grounded grounding-type receptacle to reduce the
risk of electric shock.
2. Attach the pump to the water tank using the four suction feet on the bottom of
the pump. Position the pump so neither it nor the hose will interfere with the
motion of the table while cutting and so that it can be completely submerged
in the water.
3. Never handle the pump by the cord, with wet hands, or when standing on a
wet surface. Never pick up the pump while it is plugged in.
4. Do not use the pump to pump anything other than water, or other compatible
liquids. Never use the pump to pump gasoline, kerosene, or other
combustible or corrosive liquids.
5. Should the pump fail, always disconnect from the power source before
handling the pump or attempting to unclog or service the pump in any way.
6. Never let the pump operate dry. It is self-cooled by the liquid pumped. Dry
use will cause pump damage and may cause the motor to fail .
TABLE
1. Slide the table holder through the middle of the rail cover and fit the two
inserts over the ends of the cover to prevent the table holder from slipping
out.
2. Attach the rail and table assembly to the frame using two sets of the bolts,
flat washers and toothed lock washers as shown in the assembly diagram.
CHANGING / INSTALLING THE BLADE
1. WARNING: Be sure the power cord is unplugged from its power source.
2. Loosen the Blade guard lock knob ( O in Functional Description, above ),
located on the side of the Blade guard ( P in Functional Description, above )
and raise guard.
3. Tighten the knob to hold the guard in an “up” position.
. Depress the Shaft lock button ( I in Functional Description, above ) while
turning the blade (or spindle if you have not yet installed a blade) with your
hand until the Shaft lock button depresses fully. This will prevent the spindle
from spinning and allow you to unscrew the nut and outer flange.
5. Slide the blade over the spindle, pushing it up against the inner flange. It
is important to be sure the directional arrow on the blade is pointing in the
direction of rotation marked on the blade guard.
6. Replace the outer flange onto the shaft followed by the blade shaft hex nut
7. With one hand press and hold the blade shaft lock, then with your free hand
tighten the blade shaft nut. Make certain the nut is firmly tightened with the
wrench provided. DO NOT OVER-TIGHTEN .
8. Release the blade shaft lock after the blade shaft nut is fully tightened.
9. Lower the blade guard and tighten the lock knob.
ASSEMBLY
!