WatchPAT™200 System
48
Operation Manual
9.2 Patient Error Messages
If an error message is displayed when the patient powers on the WatchPAT™ device,
the patient should take the actions specified below. If the problem persists the patient
may contact Itamar or an authorized representative directly.
Table 2
– Patient Troubleshooting
Error
Possible Reason
Action
Oximetry sensor light
turns off while
WatchPAT™ device is on.
Oximetry sensor plug not fully
inserted
Verify that oximetry sensor plug is fully
inserted into the WatchPAT™ device
Faulty oximetry sensor
Check the oximetry sensor probe for damage
and replace if necessary
Oximetry sensor
disconnected
Sensor not properly connected
or faulty
Check connection. If problem persists
replace sensor
WatchPAT™ device does
not switch on
ON button not activated
Press the ON button firmly for at least 3
seconds
PAT
®
probe not connected
Ensure probe is connected and try again
Probe disconnected
Probe may not be connected,
or may be a used probe
Check connection of probe to cable and cable
to the WatchPAT™ device; check if probe has
been previously used and replace with new
probe if necessary
Hardware code
WatchPAT™ device failure
Contact Itamar or authorized representative
