WatchPAT™200 System
22
Operation Manual
3.3 Preparing the Snore and Body Position Sensor
Attach the small round double sided adhesive sticker to the white snoring sensor, by
peeling off the cover on one side of the sticker.
Apply the body positioning adhesive sticker by attaching the sticker’s smaller side to
the back side of the body position sensor (without the Itamar logo).
For more details see Appendix A: WP200 Integrated Snoring + Body Positioning
Sensor Operating
3.4 Preparing the Wrist Strap
The wrist strap requires no special preparation other than ensuring its cleanliness. You
may clean it if needed. Take care not to allow the oximetry module or connector to get
wet (see Figure 5). See section
6.1 for detailed cleaning instructions.
Figure 9
– Wrist Strap
Warning - Nonin sensor
Do not use a damaged sensor. If the sensor is damaged in any way,
discontinue use immediately and replace the sensor.
Do not use caustic or abrasive cleaning agents on the sensors.
Do not autoclave or immerse in liquid of any kind.
Oximetry module
Oximetry module
connector
Oximetry sensor
