Italkero Fiammella, Руководство по установке

Страница: 36 / 40

Removing the casing
Remove the fastening screws (1) of the cover (2).
Carefully raise and remove the flame cover glass (3)
with rear support fastenings.
Raise and remove the two side panels (4), freeing
these of the fastening tangs (5).
Fitting the casing back on
Fit the casing back on in the reverse sequence to
removal, being very careful when fitting the flame
cover glass (3) with rear support fastenings back
on.
36 CUSTOMER SERVICE
DISASSEMBLY & RIASSEMBLY OF THE SKIRT
FAULT CAUSE REMEDY
Installed nozzles not suitable for
gas used
Fit right nozzles
Control board faulty Replace
Power supply disconnected / Check.
The appliance does not start
Incorrect gas pressure Set correct pressures
Thermostat fails to engage Adjust the thermostat
Burnt-out fuse Replace
Control board faulty Replace
High room temperature Room thermostat set too high.
Air in gas pipes Bleed
Incorrect ignition electrode
distance Reset the correct distance
The appliance fails to start
(appliance not working properly /
blocked)
Nozzles dirty Clean nozzles
Gas valve closed
Check / Replace:
- Safety thermostat tripped (tang.
fan or faulty thermostat, gas
setting)
- Valve faulty
No signal from pressure switch. Check/Replace:
- not suitable pipes (diameter, length,
curves, fitting)
- pressure switch (operation/connections)
- small pipes (cleaning)
- centrifugal fan (connection/operation).
Wrong programming of segments Adjust the segments.
The timer does not engage or
does not work
Wrong function programming Position on "clock"
Power supply switch OFF.
Reset and re-programme the timer.
2
1
4
4
5
3
EVENTUAL ANOMALY