Italkero faro, Установка и послепродажное обслуживание

Страница: 36 / 40

Removing the casing
Remove the retention screws (1 or 5) depending on the
cover (2 or 4) chosen according to the jobs to be done.
Very carefully remove the front or rear panel (3) as
shown in the front and rear panel Assembly and
removal Chapter.
To remove the front panel (3), there is no need
to remove both covers (2 and 4). Removing just
one of these is enough.
Fitting the casing back on
Fit the casing back on in the reverse sequence to
removal,
with special care given to fitting the
panel (3) back on.
36
CUSTOMER SERVICE
DISASSEMBLY & RIASSEMBLY OF THE SKIRT
FAULT CAUSE REMEDY
Installed nozzles not suitable for
gas used
Fit right nozzles
Control board faulty Replace
Power supply disconnected / Check.
The appliance does not start
Incorrect gas pressure Set correct pressures
Thermostat fails to engage Adjust the thermostat
Burnt-out fuse Replace
Control board faulty Replace
High room temperature Room thermostat set too high.
Air in gas pipes Bleed
Incorrect ignition electrode
distance Reset the correct distance
The appliance fails to start
(appliance not working properly /
blocked)
Nozzles dirty Clean nozzles
Gas valve closed Check / Replace:
- Safety thermostat tripped (tang.
fan or faulty thermostat, gas
setting)
- Valve faulty
No signal from pressure switch. Check/Replace:
- not suitable pipes (diameter, length,
curves, fitting)
- pressure switch (operation/connections)
- small pipes (cleaning)
- centrifugal fan (connection/operation).
Wrong programming Adjust the program.
The timer does not engage or
does not work
Wrong function programming Position on "AUTO"
Power supply switch OFF.
Reset and re-programme the timer.
Wireless synchronization inactive Synchronize the Wireless
2
4
1
3
5
EVENTUAL ANOMALY