Italkero Eco SC Series, Установка и послепродажное обслуживание

Страница: 23 / 40

23 INSTALLER
se model (electronic ignition), procedure:
- Disconnect the electrical power supply.
- Remove the jacket.
- Shut off the gas supply and disconnect the pipes.
- Disconnect the gas pipe collar from the injector mount
fitting;
- Undo the injector mount fitting (4) with the burner
injector (5);
- Undo the injector (4) and replace it with a new one,
making sure to thread it fully on by hand and then
tighten it down with a wrench.
The injector and injector mount fitting mount tightly to
each other, there is no need for a gasket;
- Check that the value impressed on the injector
matches that given in the table.
- Restore the burner unit in reverse order.
- Make the adjustments indicated in Chapter
ADJUSTMENTS; also check that the gas fittings on the
pipe running from the gas cock to the burner unit are
tight.
- Change the gas label (see IDENTIFICATION) and seal
the adjustment equipment once it is calibrated, with a
drop of paint or silicone.
Never leave the old gas label on the appliance; this can
lead to misunderstanding and is hence very hazardous.
MODEL
18
30
METHANE
1 , 2 5
1 , 6 5
L P G
0 , 7 3
0 , 9 5
45
1 , 9 8 1 , 1 6
mm
Ø
Ø
Ø
se
se